Skip to content

Ultrasonic Range Finder - XL-MaxSonar-WR1

This is the new, weather resistant, field-hardened WR1 from Maxbotix. The XL series of this sensor features higher resolution, longer range, higher power output and better calibration when compared to the LV version.

The WR1 uses a robust PVC housing, is designed to meet IP67 water intrusion, and matches standard electrical ¾" PVC pipe fittings. The sensor provides very accurate readings from 0 to 765cm (0 to 25.1ft) with 1cm resolution. This sensor can be powered with anywhere between 3.3 and 5VDC.

Range information can be gathered through one of three methods - analog, serial, or PWM - all of which are active at the same time. The analog output will produce a voltage proportional to the measured distance, with a sensitivity of (Vcc/1024)V/cm. The serial interface is simple and formatted to RS-232, with voltages ranging from 0 to Vcc and terminal settings of 9600-8-N-1. Finally, the PWM pin outputs a pulse-width representation of the range with a scale factor of 58us/cm.

Note: The High-Resolution version of this sensor is now available so this one is being discontinued. We’re now selling them at a reduced price so get them while you can! The High-Resolution version can be found here.

Features:

  • 3.3V to 5V supply with very low average current draw
  • All interfaces are active simultaneously
    • Serial, 0 to Vcc
    • 9600 baud, 8-N-1
    • Analog, (Vcc/1024) / cm resolution
    • Pulse Width
  • High acoustic power output
  • Real-time auto calibration and noise rejection for every ranging cycle
  • Precise narrow beam
  • Continuously variable gain
  • Object detection includes zero range objects
  • Readings can occur up to every 100mS, (10-Hz rate)
  • Free run operation can continually measure and output range information
  • Triggered operation provides the range reading as desired
  • Sensor operates at 42KHz

Documents:

The Ultrasonic Range Finder - XL-MaxSonar-WR1 appears in the following collections:

SKU SF-SEN-09496